Special Clamps

Active filters

  • ,
    5/ 5
    <p>Ideal for gluing linings and edges.</p> <p>Brass, finely machined.</p> <p>Jaw depth 18 mm</p> <p>Jaw opening 15 mm</p> <p></p>
    030.243
    Edge Clamp with Single Screw GL Clamps

    Edge Clamp with Single Screw

    €9.75
  • ,
    5/ 5
    <p>Small specialty tool for gluing cracks. Galvanized steel. (Can be tightened with a M2 hex wrench, not included). The blocks lining the crack are cut off after gluing.</p> <p>Opening 12 mm, Depth 5 mm.</p> <p></p>
    030.241
    Herdim Crack-Gluing Clamp Herdim Clamps

    Herdim Crack-Gluing Clamp

    €4.84
  • ,
    5/ 5
    <p>For regluing rib corners. After attaching the clamp to the rib corner area, pressure can be applied directly to both sides of the rib corner using the small perpendicular spindles.</p> <p></p> <p>Jaw opening 50 mm (violin/viola), 150 mm (cello)</p> <p></p>
    030.222
    Herdim Rib Corner Clamp Herdim Clamps

    Herdim Rib Corner Clamp

    €129.43
  • ,
    5/ 5
    <p>These chrome-plated bar clamps can exert light to medium pressure. These clamps feature holes drilled at intervals into the back of the bar to accept the point of the thumbscrew rod, allowing the clamps to be used a higher pressures without worrying that the arm might slide. Not only for glue-up, these clamps give good service as well for marking and sawing multiple boards at the same time.</p> <p></p>
    030.209
    Hatagane - Japanese Bar Clamps in Steel Hattori Clamps

    Hatagane - Japanese Bar Clamps in Steel

    €17.95

    These chrome-plated bar clamps can exert light to medium pressure

  • ,
    5/ 5
    <p>These parallel clamps are often used for fixing small metal components during drilling and threading on machines. The clamps are also used in many other areas thanks to their compact and simple design. Powder-coated jaws, gunmetal-finished torsion-resistant spindles</p> <p></p>
    030.127
    Toolmaker's Clamp GL Clamps

    Toolmaker's Clamp

    €14.67

    These parallel clamps are often used for fixing small metal components during drilling and threading on machines

  • ,
    5/ 5
    <p>Japanese bar clamps are not designed to develop a lot of pressure, so they can be lightly constructed with eye-pleasing lines. They are well suited, especially the smaller clamps in solid brass, to work on display, or anywhere the use of such elegant tools will be appreciated (even if only by you!). The delicate tools allow finely-fitted small and delicate work pieces to be clamped for fitting and glueing. The clamping depth is limited, so the workpiece normally lies directly on the polished bars, allowing precise clamping while making it less likely the piece will slip out of alignment.</p> <p>These delicate clamps allow finely-fitted small and delicate work pieces to be clamped for fitting and glueing. Length of these brass clamps is approx. 25 mm more than the clamping capacity.</p> <p></p>
    030.204
    Hatagane - Japanese Bar Clamps in Brass Hatagane Clamps

    Hatagane - Japanese Bar Clamps in Brass

    €8.93

    These delicate clamps allow finely-fitted small and delicate work pieces to be clamped for fitting and glueing